Week 11,12,13 FYP 2

Activity:

After the mid semester I reach to my supervisor to show my project to get approval and continue with the test. I continue testing the product, the test is conduct from 9am to 5pm. The temperature reading take every each an hour. To test the product, I put the product on the backseat. Set up the motion sensor and temperature sensor on the roof. This test conduct for 3 weeks  from week 10 to week 13 and test on 6 different vehicles.

Product place inside the vehicle

Objectives:

To record temperature reading after placing the product in vehicle.

To compare temperature reading between place the product and before.

Conclusion:

To test the product, must place the product at same position in vehicle and test on the same weather. The temperature reading recorded and compared, from the comparison found out for each type of vehicle have same reading. The temperature reading take in 2 decimal place value. Comparison between the type vehicles, the compact vehicle recorded highest temperature in vehicle this is because of the size of vehicle and limited air circulation. The objective of this project partial achieved, for cooling objective for cooling air inside the vehicle however didn’t manage to reduce to 27 Celsius but did manage reduce to comfortable heat.